Operation Manual

Helpline No. UK/Northern Ireland 0800 328 6020
Rep. Ireland 00800 4467 5888
E-mail Support [e-mail]
Model Number: GT-RD-2R/GT-RD-1T
18
Helpline No. UK/Northern Ireland 0800 328 6020
Rep. Ireland 00800 4467 5888
E-mail Support [e-mail]
Model Number: GT-RD-2R/GT-RD-1T
19
NOTE:
For permanent installation of the device, skilled
handling of tools is necessary. If necessary, please
contact an electrical engineer, if you have no tools
orarenotexperiencedinhandlingtools!
Installation of the receiver
For installation on plaster or brickwork:
1. Drill 30 mm deep (ø 5 mm) with an impact drill;
2. Insert wall plugs (S5) in the drill hole;
3. Turn in a suitable screw (head diameter not larger
than 7 mm), such that the head protrudes approx.
5 mm.
4. Suspend receiver.
For installation on wood or similar:
1. Drill approx. 0.5 mm (ø 2 mm) deep using a drill.
2. Turn in a suitable screw (head diameter not larger
than 7 mm), such that the head protrudes approx.
5 mm.
Startup and installation
3. Suspend receiver.
Installation of the transmitter
NOTE:
The wall bracket for the transmitter (14) should
be attached to the wall without a gap, because
water could otherwise penetrate the housing and
damage the electronic parts.
Thetransmittershouldalwaysbeinstalledhorizon-
tally. You can label the transmitter with a name.
The name field (3) is covered with a film. The film
can be removed in the area of the LED function
control (4) (press in with fingernail).
For installation on plaster or brickwork:
1. Maketwohorizontalmarksatadistanceof65mm.
2. Drill 30 mm deep (ø 5 mm) with an impact drill;
3. Insert wall plugs (S5) in the drill hole;
Startup and installation