User's Manual

ManualsBrandsGlobalscale Technologies ManualsElectronics88MW302 Development Kit

Table Of Contents

MW302 Quick Start Guide page 1 / 1

 1/1



MW302DVBQuickStartGuide



A. PackageList:

1) MW302DVBx1

2) Mini‐USBcablex1

3) Micro‐USBcablex1



B. SystemRequirements:

ComputerwithWindowsXP/Vista/7orLinux



C. Software

 HyperterminalinWindowsorthirtypartyfreewarelikeputty.exe。



D. Installation



Step 1: ConnectMW302DVBtoyourPCviamini‐USBtoUSBcable.

Connect to PC USB port

Summary of content (8 pages)

PAGE 1
MW302 Quick Start Guide page 1 / 1 MW302 DVB Quick Start Guide A. Package List: 1) MW302 DVB x 1 2) Mini‐USB cable x 1 3) Micro‐USB cable x 1 B. System Requirements: Computer with Windows XP/Vista/7 or Linux C. Software Hyper terminal in Windows or thirty party freeware like putty.exe。 D. Installation Step 1: Connect MW302 DVB to your PC via mini‐USB to USB cable.
PAGE 2
MW302 Quick Start Guide page 2 / 2 Step 2: Check the COM port: Right click “my computer” then “Device Manager” find the Ports(COM & LPT) then write down the COM port number as shown below.
PAGE 3
MW302 Quick Start Guide page 3 / 3 Step 4: List the commands menu: help 3/3
PAGE 4
MW302 Quick Start Guide page 4 / 4 Step 5: Connect to default Wifi AP by using cell phone or another computer input command “wlan‐mac” and you will see the SSID name “wmdemo‐FC9E” , connect to this SSID with your cell phone, the password is “marvellwm”. (The SSID name is “wmdemo‐xxxx”, xxxx means the last four characters of the MAC address) For example: SSID: wmdemo‐ FC9E Step 6: Run and open the browser on your cell phone then input the IP address: 192.168.10.
PAGE 5
MW302 Quick Start Guide page 5 / 5 Step 7: Connect to your wireless router: 5/5
PAGE 6
MW302 Quick Start Guide page 6 / 6 Step 8: Switch to Wifi‐AP mode: Switch to Wifi‐AP The serial com port will show message as following: 6/6
PAGE 7
MW302 Quick Start Guide page 7 / 7 Step 9: Press the reset button to reboot the system.
PAGE 8
FCC Compliance Statement: This device complies with Part 15 of the FCC rules. Operation is subjected to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.