Data Sheet

FCC
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular
transmitter
2.3 Specific operational use conditions
This module is stand-alone modular.If the end product will involve the Multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter in
a host, host manufacturer have to consult with module manufacturer for the installation method in
end system.
2.4 Limited module procedures
This module is single modular with shielding.
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
2.7 Antennas
The following antenna will be used with the Atmosic BLE module and integrated into Globalscale
Technologies INC products,The Atmosic BLE module is not designed for multiple antenna
applications and should not be used to transmit simultaneously with any other transmitter. The
Atmosic BLE module is only certified to use the PCBantenna. Antenna Description:PCB antenna,
1.5dBi(Max.)
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC
ID:YCJGTIBLEATM-2022.
2.9 Information on test modes and additional testing requirements
Host manufacturer which install this modular with limit modular approval should perform the test
of radiated emission and spurious emission according t o FCC part 15C:15.247 and 15.209
requirement, only if the test result comply with FCC part 15.247 and 15.209 requirement, then the
host can be sold legally.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all
other applicable requirements for the system such as Part 15 B.