User's Manual

Quick Start Guide – DreamPlug page 6 / 11
E. Connect to JTAG board
F. Tools and files you need to start debugging
1. Prepare one PC with Fedora 9 (or Fedora 11) Linux operating system
2. Download and install the following tools and utilities
2. Connect 8 pin JTAG cable
1. Connect 4 pin UART cable
3. Connect Mini USB cable here.
The other end to computer’s
USB port.
This is the standard 20pin JTAG connector which has the same pin signals as 8 pin cable
Normally, this switch (or jumper wire) should
be on the left side for UART selection
This DC 2.5V is for Dream Plug CPU
e-fuse programming only, do not use it
for other purpose.