User Manual

of the mount and the holder. Then screw the Handlebar
Mount together tightly again.
You can now place your TomTom RIDER in the Holder. See this
section: Placing your TomTom RIDER in the Holder
Handlebar adaptor
[standardMount3.jpg]
[standardMount6.jpg]
[standardMount5.jpg]
[standardMount4.jpg]
The Handlebar Adaptor is secured by bolts next to the grip, as
shown. To use this mount, follow these steps:
1. Carefully remove the bolts that hold the grip in place. Do not
remove the grip from the handlebars.
2. Place the Handlebar Adaptor over the bolt holes.
3. Use the extra-long bolts provided to attach the Handlebar
Adaptor and the grip to the handlebars. Use an Allen key (not
provided) to tighten the bolts.
4. Attach the Handlebar Mount to the Handlebar Adapter. Follow
steps 2 – 4 in the section Handlebar Mount above.
You can now place your TomTom RIDER in the Holder. See this
section: Placing your TomTom RIDER in the Holder
Mirror Mount
[mirrormount2.jpg]
[mirrormount7.jpg]
The Mirror Mount is held in place by the wing mirror. If your
motorcycle or scooter has no mirrors but has the bolt holes for a
wing mirror, you can still use the Mirror Mount. To use this mount,
follow these steps:
1. Unscrew one of the wing mirrors on your motorcycle.
2. Place first the rubber washer, then the Mirror Mount and finally
the metal washer over the bolt hole, as shown in the diagram.
Note: The washers help to prevent the mirror mount from
moving or from being damaged. Select the diameter of the
washers according to the diameter of the bolt hole.
3. Screw the wing mirror back into place. The wing mirror holds