User Manual

Using your TomTom RIDER
[FromPoster5.jpg] 1. Open the compartment on the bottom of your TomTom
RIDER.
2. Push the memory card into the memory card slot.
3. Press and hold the On/Off button for 2 seconds, or until your
TomTom RIDER starts.
The first time you switch on your TomTom RIDER, it may take up to 20 seconds to start.
To switch off your TomTom RIDER, press and hold the On/Off button for 2 seconds.
Setting up
First, you have to answer a few questions to set up your device and your Bluetooth
headset module. Answer the questions by tapping the screen. You will use the
touchscreen for everything you do with your TomTom RIDER.
Follow the instructions to establish a Bluetooth connection between your TomTom RIDER
and your Bluetooth headset module. See the Bluetooth headset module section below for
more information about your Bluetooth headset module.
Once you have answered the questions, your TomTom RIDER will display the Driving
View.
The screen is shown in black and white until your TomTom RIDER locates your current
position. Once this is done, the Driving View is shown in full colour.
Locating your current position
Your TomTom RIDER must be outside to be able to locate your current position. The first
time you start your TomTom RIDER, it takes up to 5 minutes for the device to find your
current position. In future, your position will be found much faster, normally within a few
seconds. If your TomTom RIDER takes longer than 5 minutes to locate your current
position, make sure that you are in an open place without tall buildings or trees around
you.
Your TomTom RIDER does not transmit your location, so others cannot use it to track
you while you are driving.
Note: Before driving with your TomTom RIDER, we recommend that you charge it
fully using the home charger.
TomTom RIDER uses a GPS receiver to locate your current position. For more information
about GPS, see this chapter: What is GPS?
Bluetooth headset module
[NumbersBT1.jpg]
[NumbersBT2.jpg]
1. Indicators
2. Volume controls
3. On/Off button
4. Charging connector
5. Headset connector