Installation & Assembly

Page 1 of 2
WARNING : Make sure that all electricity is turned off at the "J" Box before installing this fixture
It is recommended that this fixture is installed by a licensed electrician
PARTS INCLUDED:
(A)
1 - "J" BOX MOUNTING STRAP
(B)
1 - THREADED PIPE
(C)
1 - CANOPY
(D)
1 - DECORATIVE METAL CHAIN
(E)
1 - CROWN PENDANT
(F)
4 - BALL SCREWS FOR ATTACHING GLASS SHADE IN CROWN PENDANT
(G)
1 - GLASS SHADE
NOTE: THIS FIXTURE HOLDS TWO 40 WATT (MAXIMUM) CANDELABRA (TYPE B) BULBS
ASSEMBLY INSTRUCTIONS:
STEP ONE : Unpacking Fixture:
- Unpack all the items of Crown pendant on a soft surface
- Do not discard anything until assembly is complete
STEP TWO: Attaching the Fixture:
- Release the canopy (C) over the chain to access the threaded pipe (B)
- Secure the "J" Box Mounting Strap (A) with the attachment screws to the ceiling "J" box
- Screw threaded pipe ( B) into "J" Box Mounting Strap (A)
- Snake electrical cord through threaded pipe (B)
- Attach fixture to Threaded pipe (B) by screwing end of chain to threaded pipe
STEP THREE: Wiring the fixture:
NOTE: MAKE SURE FIXTURE IS PROPERLY GROUNDED
BEFORE INSTALLING
- Attach the grounding conductor wire to the grounding screw
( identified with green color ) on the mounting Strap (A)
- Connect the live and neutral wires to the appropriate wires in the "J" box
Use wire connectors (not included) to ensure the connections are secure
STEP FOUR: Assembling the fixture:
-Once the mounting strap (A) is attached to the "J" box and all the electrical wires are
securely connected, cover the mounting Strap (A) with the Canopy (C) Tighten the screw on
the side of the canopy to hold it in place
- Loosen all 4 Ball screws (F) from Crown pendant (E)
- Install two Candelabra (TYPE B) Bulb maximum 40 W
- Attach the Glass Shade (G) to Crown pendant (E) by tightening back all 4 Ball screws
- Insure the Glass Shade is attached properly with Pendant
9.92091-B - Crown Pendant - Nickel
Assembly and Installation Instructions