User Manual

Global Truss user instructions----ST-180 light stand

5. ADDING AND LOWERING OF THE LOAD

1): Position an adaptive accessory (truss adapters, T-bars, etc…) on

the top mast. Lock the handle of compensation of the block to

the accessory on the top mast.

2): with an additional lifting system, Position and fix the load on

the top of the accessory. Care must be taken to prevent any

sliding of the load which would cause an overhang.

3): Reverse the adding load procedure to lower of the load.

6. RESTORING AND TRANSPORT THE STAND

1): Reverse the lifting the masts procedure to restore the masts.

Make sure that all the ABS (AUTOPIN BLOCKING SYSTEM

(I)) are locking in the lowest position hole, and tighten all

locking knobs (G).

2): Reverse the position the stand procedure to fold up the legs.

Make sure that all of the spring pin (K) and the screw handle (L)

are restored to lock the leg-brace slider(C) to the leg (F).

Tighten all of the leg-brace screw jacks (D) to make sure all of

the legs (F) are in the vertical position.

3): Turn the winch handle (H) until the cable is tight.

4): Your stand is ready for transport.

 The steel cable must be correctly and completely rolled up to

avoid any crushing of the fibers.

 The stand can be transported in a vertical or horizontal

position.