User Manual

Global Truss user instructions----ST-180 light stand

Technical date

3. POSITIONING THE STAND

1): Place the stand in the vertical position on its wheels (J).

2): Ensure that the ground in strong enough to prevent any sinking

of the stand into the ground. The stability of the stand is of

prime importance for a secure operation.

3): Pull out the spring pin (K), and screw out the screw handle (L)

to unlock the leg-brace slider(C) and flip the leg (F) from

vertical into horizontal position.

4): Choose the closest of the holes in the leg (F) and restore the

spring pin (K) and the screw handle (L) to lock the leg-brace

slider(C) to the leg (F).

5): Repeat step 3) and 4) with the other 3 legs.

6): Use the leg-brace screw jacks (D) to ensure the footplate (E)

touches the ground.

7): Continue turning the screw jacks (D) of each leg in sequence

until the wheels (J) slightly lift off the ground (5-10mm is

recommended).

8): When used on a sloping surface, the footplates (E) must be

secured to the ground to avoid any sliding.

9): When the stand in securely positioned and vertical, check again

that the leg-brace sliders (C) are properly locked into their holes

in the foot (F).

ST-180

Maximum load: 180kg 450lb.

Maximum height: 5.5m 18`0”

Minimum height: 1.77m 5`1”

Footprint: 2.17m 7`2”

Weight: 104kg 229lb

Closed size: 1.77m 5`1”

Material: treated steel

Finish: Epoxy black painting / electro-galvanized