User Manual

2. Plug the end of the coiled handset cord into the Handset jack on the rear of the

phone. Secure the cord by routing it through the slot and underneath the tab.

3. Plug one end of the Ethernet cable into the Ethernet port on the rear of the

deskset (marked by ), and plug the other end of the cable into your

network router or switch.

Note: You may need to use a network switch connected to your router if your

router does not have sufcient ports for the number of phones you want to

install. If you use a network switch, connect the phone to the switch instead

of the router in the previous step.

4. If the deskset is not using power from a PoE-capable network router or switch:

a. Connect a power adapter to the deskset power jack.

b. Plug the power adapter into an electrical outlet not controlled by a wall

switch.

If there is a networked computer and no extra Ethernet wall jacks near the phone,

then the phone and PC can share the same network connection.

To share a network connection with a PC:

1. Plug a Cat.-5 Ethernet cable into the PC port on the phone (marked by ).

2. Plug the other end of the Cat.-5 Ethernet cable into the computer’s Ethernet port.

• If a PC is connected to your network through a phone, any phone resets

and power or network interruptions will disrupt the PC’s connection to the

network.

To network switch or router

Shared network connection

to computer

To electrical outlet (if required)

To insert a microSD card (optional):

1. Release the microSD card cover and swivel it out of the way.

2. Insert a microSD card (oriented as shown on the phone), pressing it down

with a ngernail until it clicks into place.