User Manual

4
Getting Started
To power the VCS752 using PoE:
1. Plug one end of the Ethernet cable into the Ethernet port on the bottom of the unit.
2. Plug the other end of the cable into your network router or switch. When the base
unit is powered up, the status indicators turn green for about two seconds.
Note: You can connect the VCS752 to both PoE and AC power. Ensure that you
connect the cables in the order shown in the diagram on page 2. Once connected,
the unit will use PoE. If PoE fails, the unit will use AC power as a backup.
Install the wireless mic battery
1. Plug the battery connector securely into the socket inside the battery
compartment. Insert the battery (with the label THIS SIDE UP facing up) into the
battery compartment.
2. Slide the battery door until it clicks into place.
3. Place the wireless mic onto the charging cradle until it is ush.
Note: The status indicator on the wireless mic turns orange when charging, and turns
off when the wireless mic is fully charged.
3
AC power cord
1
2
LAN
VCS752
Wall outlet
Network switch
or router
DC power cable
(with yellow plugs) Ethernet cable
Slots
To Adapter
Adapter
Network switch
or router
Ethernet cable
Slots
Battery X2
3
AC power cord
1
2
LAN
VCS752
Wall outlet
Network switch
or router
DC power cable
(with yellow plugs) Ethernet cable
Slots
To Adapter
Adapter
Network switch
or router
Ethernet cable
Slots
Battery X2