User's Manual

of RF exposure, and what to do to as-sure that this radio operates with the FCC RF
exposure limits of this radio.
Electromagnetic Interference/Compatibility
During transmissions, Global Mei Chuang Co., Limited radio generates RF energy that can
possibly cause interference with other devices or systems. To avoid such interference, turn
off the radio in areas where signs are posted to do so. DO NOT operate the transmitter in
areas that are sensitive to electromagnetic radiation such as hospitals, aircraft,
and blasting sites.
Occupational/Controlled Use
The radio transmitter is used in situations in which persons are exposed as consequence
of their employment
provided those persons are fully aware of the potential for exposure and can exercise
control over their exposure.
Attention:
This radio complieswith IEEE and ICNIRP exposure limits for occupational/controlled RF
exposure emvironment
at operating duty factors of up to 50% and is authorized by the FCC for occupational use
only. An appropriate
warning lable is affixed to all units. In order to comply with RF exposure requirements, a
minimum distance of
2.5 cm must be maintained when held-to-face, and body-worn operations are restricted to
the approved original
acessories (belt clip), a minimum distance of 0 cm. Do not use this device when antenna
shows obvious damages.
This product is compliance to FCC RF Exposure requirements and refers to FCC website
https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm search for FCC ID:
2AMEAWT1838 to gain further
information include SAR Values.
This EUT is compliance with SAR for controlled exposure limits in IC RSS-102 and had
been tested in accordance with the measurement methods and procedures specified in
IEEE 1528 and IEC 62209. This equipment should be installed and operated with a
minimum distance of 2.5cm must be maintained when held-to-face, and body-worn
operations are restricted to the approve original accessories.
Cet EUT est conforme au SAR pour les limites d'exposition contrôlées définies dans l'IC
RSS-102 et a été testé conformément aux méthodes et procédures de mesure spécifiées
dans IEEE 1528 et IEC 62209. Cet équipement doit être installé et utilisé à une distance
minimale de 2.5 cm. être maintenu en place, et les opérations portées sur le corps sont
limitées aux accessoires d'origine approuvés.