Owner's Manual

continuously from 1 to 8. Once an active channel is found, the
scanning will stop and you can listen to the transmission.
When the transmission is on the found channel stop, the scanning will
resume automatically.
Note: If you press PTT button while listening to a found channel, the
device will go back to stand-by mode on the found channel.
4.9 Monitor
Press and hold the DOWN ▼ button about 3 seconds to active monitor.
Release the DOWN▼ button return to stand by m ode.
4.10 Setting the Call tones
The device has 10 call tones.
Press the MENU button 4 times, “CA” is displayed and on the current
call tone.
Press the UP▲/Down▼ button to change another call tones.
Press the PTT button to confirm and return to stand-by mode.
4.11 Sending a call tone
Press the PTT button one time quickly, the call tone will be transmitted
on the setting channel.
4.12 Key Tone On/Off
You can on/off the key tone when press the buttons.
Press the MENU button 5 times, “KO” will be displayed.
Press the UP▲/Down▼ button disable the key tone ON/OFF.
Press The PTT button to confirm your selection and return to the
stand-by mode.
4.13 Roger Beep On/Off
After the PTT button released, the device will send out a roger beep to
confirm that have stopped talking.
Press the MENU button 6 times, “RO” will be displayed.
Press the UP▲/Dow n▼ button disable the roger beep ON/OFF.
Press The PTT button to confirm your selection and return to the
stand-by mode.
4.14 Backlit display
Press any button except for the MENU button to activate the back light
of the LCD display. The back light will light on about 5 seconds.
4.15 Battery saving function
When the device has not been used for 6 seconds, the economy mode
is automatically activated. This does not affect the reception of
transmission and the stand by mode is automatically re-activated as
soon as a signal is detected.