Owner's Manual

7, VOX (Hands free function)
Press the MENU button three times, the current
VOX setting will flash on the display and the VOX
icon will display.
Press UP▲ button to set the VOX sensitivity level
between 1~3 level (level 3 is the high sensitive level).
Press down▼ button until “OF” appears on the display
to turn VOX off.
Press the PTT button to confirm and return to
stand-by mode.
In VOX mode, the radio will transmit a signal when
it is activated by your voice or other sound around
you. VOX operation is not recommended if you plan
to use your device in a noisy or windy environment.
Note: VOX mode will be over ride when you press the
PTT button.
8, Scanning for an Active Radio Channel
Press and hold the UP▲ button 2 seconds: The
“SCAN” function indicator will appear on the display
and the channel will scan continuously from 1 to 22.
Once an active channel is found, the scanning will
stop and you can listen to the transmission.
When the transmission is on the found channel
stop, the scanning will resume automatically.
Note: If you press PTT button while listening to a
found channel, the device will go back to stand-by
mode on the found channel.
9, Monitor
Press and hold the DOWN▼ button about 3 seconds
to active monitor.
Release the DOWN▼ button return to stand-by mode.
10, Setting the Call tones
The device has 10 call tones.
Press the MENU button 4 times, “CA” is displayed and
on the current call-tone.
Press the UP▲/Down▼ button to change another call
tones.
Press the PTT button to confirm and return to stand
-by mode.