Owner's Manual

Before Use the device
Removing the belt clip
Before insert batteries into the device, first pull
the belt clip latch away from the device.
Installing the Batteries
1, Slid down the battery compartment cover.
2, Insert 3* AAA Alkaline (Not included)
3, Position the batteries according to the polarity
Making on the battery compartment.
4, After placing batteries into correct positions,
Replace the battery cover.
Using the device
1, Turning the Device on/off
Switch on the device: Press and hold on the 3
seconds then you will hear a beep sound.
Switch off the device: Press and hold the 3
seconds then you will hear a beep sound.
2, Adjusting the volume
To increase the volume, press the Up ▲ button.
And press the Down ▼ button to decrease the
volume.
3, Low Battery Indication
The device can detect the low battery level when
the battery voltage goes low. When battery
voltage is low, the battery icon will flash and a
beep will be heard to indicate that the batteries
need to be replaced.
4, Receiving/transmitting communications:
The devices are in “standby” mode when it is
turned on and no transmitting. When a signal is
received on the current channel, the LCD will
display receiving icon in “reception” mode.
When you press the PTT (push to talk) button,
the devices switches to “Transmission” mode.
Hold the device in a vertical position with the Mic
3-5cm away from your mouth. While holding the