User Manual

OPERATION

1. Install the BATTERY in the COMMUNICATOR.

2. Enter COMMUNICATOR mode by pressing and holding the POWER/MODE button for

3 seconds. To exit COMMUNICATOR mode, press the POWER/MODE button for 3

seconds.

3. Check for the LOW BATTERY LEVEL icon on the LCD Screen.

4. Adjust the Speaker Volume to a comfortable level by pressing the UP

or DOWN

button (default).

Navigating through the Menu

Use the POWER/MODE button to access the advanced features of the COMMUNICATOR.

(See pages 9-15 for programming instructions.)

COMMUNICATOR Mode:

The COMMUNICATOR functions as a two-way communication device while in

this mode.

1. Press the POWER/MODE button for 3 seconds and a long "beep" will be heard, the

COMMUNICATOR's LCD Screen will quickly display all of the COMMUNICATOR's

status icons, and the COMMUNICATOR will enter COMMUNICATOR mode and display

the current channel. The LCD Display Backlighting will also be lit for approximately 7

seconds.

2. Press the POWER/MODE button briefly (for no longer than 1 second) to enter into

CHANNEL CHANGE, CTCSS CODE CHANGE, POWER HI/LO, VOX, ROGER BEEP,

and STANDBY/RECEIVE modes in due order. A short "beep" will be heard after every

press of the POWER/MODE button.

3. Press the TALK button to exit the MENU mode at any time, or the unit will

automatically return to STANDBY mode if no buttons have been pressed for 10 seconds.

NOTE: In order for other people to receive your transmission, they must be on the same

channel and CTCSS Code you are currently using. Refer to the "Changing

Channels" and “Changing CTCSS Code” section for more information.

MODE Channel

VOX

1~22

On/Off

CTCSS

oF~38

Roger Beep

On/Off

Power

Hi / Lo