User Manual

OPERATION

Adjusting Speaker Volume (STANDBY/RECEIVE Mode):

1. Press the UP

button to increase the Speaker Volume.

2. Press the DOWN

button to decrease the Speaker Volume.

3. The Speaker Volume increase/decrease at each Volume increment/decrement.

NOTE: The Speaker Volume setting will not be displayed on the LCD Display.

Transmitting and Receiving a Signal:

The COMMUNICATOR is continuously in RECEIVE/STANDBY mode when the

unit is on, in COMMUNICATOR mode, and not transmitting. Changing the

position of the COMMUNICATOR may increase the quality and range of the

COMMUNICATOR's transmitted or received signals.

1. Press and hold the TALK button to TRANSMIT and the TX icon will appear on the LCD

Screen (see "LCD Screen" for details).

2. Hold the COMMUNICATOR about 2~3 inches (5 to 7.5 cm) from the mouth, and speak

in a normal tone of voice. Pause momentarily (after pressing the TALK button) before

speaking to avoid cutting off the first part of the transmission.

3. Release the TALK button when finished transmitting to return to RECEIVE mode.

4. Receipt of an incoming transmission will be indicated by the appearance of the RX icon

on LCD Screen.

Sending a CALL TONE:

Use a CALL TONE to alert the other user when attempting to contact them or

use a CALL TONE to signal the beginning or the end of a transmission.

1. Press and quickly release the TALK button twice, the TX icon will bedisplayed on the

LCD Screen and a CALL TONE will be transmitted for 3~5 seconds.

2. The COMMUNICATOR will return to STANDBY mode after completing the CALL

TONE transmission.

NOTE: All two-way communicators currently using the same channel and CTCSS Code as

the COMMUNICATOR sending the CALL TONE will receive a CALL TONE.