User Manual

4
Installation
Height Adjustment
1. Raise one end of the machine by lifting the support rails between the casters with a
forklift, pallet jack, or scissor jack. Do NOT raise the machine too high to avoid turning
over the machine. NOTE: Scissor jack and additional equipments not included. Pallet
jack requires a wood block between the fork and support bar to lift the machine.
2. Unscrew the (4) locking bolts and adjust the height of the feet. Tighten the screws
when completed.
3. Lower the machine back to the ground.
4. Repeat the above 3 steps to the other end of the machine to adjust the height of the
other two feet.
5. Make any ne adjustments, if necessary, with the threaded caster(s) to ensure the
machine leveled.
Figure 2