User Manual

3
Safety Information
The “Warning must keep ground wire
connected” warns operators to keep
the ground plug connected at all time
during operation.
The “arrow” located on each guide rail
indicate the direction where the carton
enters and exit through the conveyor.
1. DO NOT use near explosive or ammable gasses.
2. DO NOT reach into any rotating parts unless the machine is OFF and disconnected
from a power source. Hands may be caught in the moving parts which can cause
serious injury.
3. Prevent accidental starting.
Ensure machine is OFF before connecting to a power source.
4. DO NOT touch the machine or the plug when hands are wet. Wet hands can increase
the risk of electric shock.
5. Always turn o the machine and unplug the power cord when not in use. Cover the
machine to protect it from dust.
6. Do NOT pull the power cord by the cable.
Always unplug the power cord by pulling the plug.
7. Always use outlets that match the power tool plug. Never remove the grounding plug
or make any other modications. Ensure the outlet is properly installed and grounded.
Do not use adapter plugs. Using unmodied plugs and outlets helps ensure grounding
and reduces chances of electrical shock.
8. Always use a GFCI protected supply when using the machine. GFCI reduces the risk
of an electric shock.
9. Machine will gradually lower itself automatically after shutting down as the air bleeds
out. Do NOT use in corrosive atmospheres. Do NOT use in temperatures lower than 41˚
F or higher than 86˚ F.
The “Warning-Electric Shock” is attached
to the electrical enclosure on the lower left
side of the machine frame. The warning
label warns service personnel to unplug
the power supply before attempting any
service work on the case sealer.
The “Danger-pinch point” label is
attached to the center plate at the
exit end of the machine bed. The
label warns the operator to keep
hands out of this area when the
drive belts are running.
“Warning-Sharp Knife”
label is attached to the
upper conveyor belt
assembly. The label warn
operators and service
personnel of the very sharp
knife used to cut the tape
at the end of the tape
application.
“Caution-Sharp Knife” label
warns operators and service
personnel of the extremely sharp
knife used to cut the tape. Keep
hands out of these areas except as
necessary to service the tape heads
or to load/thread tape.
The “Red” emergency switch is
located on the top/front of the upper
conveyor belt assembly. If you
encounter problems during the
packaging process, press the
emergency stop switch to stop the
machine.