User Manual

11
Problem Potential Causes Solution
Tape doesn’t
adhere to the
package
Tension spring on tape head
is too weak
Friction of tape roller
lessened after use
Adjust the friction of the tape
mount
The machine does
not start
Power switch is damaged Replace the power switch
Loose wires Rewiring
Drive belt
does not turn
No power Check the power supply
Geared motor damage Replace the geared motor
Chain shedding Reinstall the chain
Bearing damage Replacement bearing
Conveyor belt is damaged
Replace the damaged
conveyor belt.
Conveyor belt is too loose
Adjust the tension of the
conveyor belt
Machine alarm Package stuck Take out the package
Maintenance
If the machine is used frequently (<4 hours a day), then professional maintenance is
recommended every six months. If usage does not exceed 4 hours per day, a complete
maintenance is recommended once per year. Keep the inside and outside of the machine
clean and dry at all times.
Frequency Maintenance
Every Day Clean o any residues on the cutting blade
Every Week
Check oil levels and drain water. Wipe the cylinder piston to
prevent dust from entering the piston cylinder or creating air
leaks.
Every Two Months Check all the screws and nuts. Tighten if needed.
Every Six Months
Replace the cutting blade. Model no. 412572
Every Year Replace the conveyor belts. Model no. 412565 & 412566
Warning! Danger of electric shock!
The power must be completely disconnected before servicing the machine.