User Manual

Max
Med
Min
A
B
Installation Procedures:
Step 2 Fill bottle with clean water. Cover the filler opening to prevent spilling, turn bottle
over and place filler opening over desired water level peg in the water reservoir.
Step 3 Adjust roll guide plates (A and B) to fit tape width. The tape should be positioned
centrally between the guide plates. Note: Maximum tape width should not exceed 3
inches(76.2mm).
Step 4 Press the cutter lightly to take out the top board.
Step 5 Press the cutter lightly and insert the tape, positioned gummed side down,
through the paper feed roller. See tape threading diagram
Step 6 Press the cutter lightly and install the top board back.
1
2
Brush
Upper and
lower cutter
Upper and
lower feed roller
Paper tape (adhesive
side downward)
Transition roller
Paper tape roll
1
2
1
2
Step 1 Insert the brush in the water
reservoir. Insert the water reservoir's pivot
shaft into the slots on the inner sides of
the dispenser. Move shaft up to the top of
the slots. Slide reservoir down so bottom
fits over tab on dispenser.
Tape threading diagram