User Manual

Table Of Contents

Model no. 412477

Electronic Tape Dispenser for 1/2" - 3" Water Activated Kraft Tape

User Manual

Changing unit:

Press and hold the Adjustment Length Knob button for 5 seconds or until the screen display

“CCC”. Switch the unit to either mm or inch; the corresponding unit indicator light is on after the

unit is selected.

Preset Setting:

1. Press the Adjustable Length Knob button to switch between L1 and L2 parameter setting.

“Set-Lamp” will light up next to either L1 digital screen or L2 digital screen to indicate the

parameter selection.

2. Rotate the Adjustment Length Knob clockwise to increase the tape length. Rotate the

Adjustment Length Knob counterclockwise to decrease the tape length. The tape length

can be set from 4 inches(101mm) to 99.9inches(2537mm).

3. After the lengths are preset, press the Adjustment Length Knob button to exit the setting

display.

4. Press the L1 button or the L2 button to use preset tape lengths.

Press the L1 button to dispense the length set on the

L1 output screen

Press the

L2 button to dispense the length set on the

L2 output screen

Press and hold the Manual button to dispense the

desired tape length. Release the button to stop

dispensing.

Operation Instructions:

Power Switch

L1 Output tape length

L2 Output tape length

Adjustable Length Kno

Press this button to set either L1 or L2 tape length.

PAGE 1
Operation Instructions: Model no. 412477 Power Switch Electronic Tape Dispenser for 1/2" - 3" Water Activated Kraft Tape L1 Output tape length L2 Output tape length Adjustable Length Knob Press this button to set either L1 or L2 tape length. User Manual Press the L1 button to dispense the length set on the L1 output screen Press the L2 button to dispense the length set on the L2 output screen Press and hold the Manual button to dispense the desired tape length. Release the button to stop dispensing.
PAGE 2
Installation Procedures: Step 4 Press the cutter lightly to take out the top board. Step 1 Insert the brush in the water reservoir. Insert the water reservoir's pivot shaft into the slots on the inner sides of the dispenser. Move shaft up to the top of the slots. Slide reservoir down so bottom fits over tab on dispenser. Step 2 Fill bottle with clean water. Cover the filler opening to prevent spilling, turn bottle over and place filler opening over desired water level peg in the water reservoir.