User Manual

Safety Instructions
Please observe the following safety instructions to avoid personal injury and property loss.
1) Do not operate any fan with a damaged cord or Plug.
2) Do not move or adjust blower while in operation
3) Keep this unit out of the reach of children
4) Do not alter or modify your blower in any way. Only authorized Global Industrial replacement parts can be
used. Use of any unauthorized parts could cause hazards and void the unit’s warranty
5) Always store unit in a clean, dry environment when not in use. Care should be taken to prevent water from
entering the unit’s motor. In the case that the unit’s motor does become wet, ensure that the motor is dried
thoroughly before use.
6) Do not allow water near or inside the unit while in use to avoid risk of electric shock. Handle unit with care to
avoid causing damage or personal injury.
7) Always operate the blower on a flat, level surface. Operating the unit where it could slip or fall increases the
risk of injury, fire, or electrical shock.
8) Never operate the blower without the factory-installed safety screens in place. This will prevent liquids, gases,
and other materials from entering the blower.
9) Do not use blower near combustible gas or flammable materials in order to avoid fire or electrical hazards.
10) Do not attempt to disassemble or repair unit on your own. Instead, bring to the attention of your distributor or
a certified repair center. Never attempt to disassemble or repair unit while blower is plugged in.
11) Prior to use, ensure the air intake and outlet are free of obstructions to prevent the blower from overheating
and causing a shock or fire hazard.
12)
Operating Procedures
The Global Industrial line of commercial ventilator is designed to efficiently and effectively ventilate, extract and
circulate air. Be sure to follow all instructions below to ensure safe and effective use.
1) Ensure that the unit is on a stable, level surface, and remains stationary while in use.
2) Plug the blower into a grounded outlet with the correct voltage and amperage. Ensure that the unit is plugged
into a grounded outlet with voltage and wattage outputs that correspond with the unit’s specifications. For
maximum protection against electrical shock, ALWAYS use a circuit that is protected by a ground fault circuit
interrupter. If you are unsure about the outlet, check with a qualified electrician.
3) Ensure that the dial is turned to your desired speed setting before turning the unit on.
Power Outlet
This blower is equipped with a built-in outlet that allows you to “daisy chain” multiple units together in order to
operate in large areas where power outlets are limited in number or unavailable. All other warnings for use of this
blower should be strictly adhered to. Total Max 12amps can be connected when the Unit is OFF.
Resettable Circuit Breaker
The thermal response resettable circuit breaker protects the unit and connected daisy chained devices. The circuit
breaker is designed to sense the total current drawn through the circuit. When more than 12 amps of electrical
current are drawn through the unit’s power cord, the circuit breaker trips. To reset, unplug the appliance causing
the breaker to trip and push the Reset Button adjacent to the outlets on the Fan.