User Manual

User’s Manual
7
Washdown Rated Stainless Steel
Pedestal and Wall Mounted Fan
Table1 Plug and socket
Wiring 115V, according to the user socket, you can choose 5-15P, 5-20P, 5-30P,5-50P.
Wiring 230V, according to the user socket, you can choose 6-15P, 6-20P, 6-30P,-50P.
MAINTAINANCE AND CLEANING
Parts replacement and troubleshooting to be
performed only by qualified personnel.
Do not depend on any switch as the sole
means of disconnecting power when installing
or servicing the fan. Failure to do so may result
in fatal electrical shock.
1.To clean the fan, use a soft damp cloth. Wipe down with a dry
cloth. Do not use cleaners that are harmful to paints or plastics.
CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners,
etc., which are dangerous and will damage the air circulator.
2 The propeller, guard, and motor should be cleaned periodically
to prevent overheating, and/or operating in an imbalanced
condition.
3. If cleaning requires the removal of a guard, remove only the
front guard and re-install when finished in its originally installed
position. Do not repair propeller if it becomes damaged.
The propeller is accurately balanced at the factory and should
be replaced if damaged.
4. Do not bend the blades.
5. Motor is permanently lubricated.
TROUBLESHOOTING
If your fan fails to operate, please follow these Instructions:
1. Make sure the fan is plugged in and the electrical outlet is working properly.
2. Check for any obstruction. If you find an obstruction, turn the fan “OFF”. Unplug the fan and carefully remove the obstruction.
3. Plug the fan in and turn it on again and see if it resumes normal.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR FAN, PLEASE DO NOT ATTEMP TO OPEN OR REPAIR THE FAN
YOURSELF. DOING SO COULD CAUSE DAMAGE OR
PERSONAL INJURY. Always consult the authorized dealer or certified electrician for further action.
CAUTION: There is no user maintenance part except regular
cleaning as following description. All other servicing or mainte-
nance should be performed by qualified service personnel.
230V/60Hz
RED
WHITE
BLACK
BLUE
ORANGE
BROWN
YELLOW
●
Connected together and insulated with the connector,
avoid the living parts touching the shell
Connected to Power Neatral Wire (White)
Insulated with the connector, avoid the living parts touching the shell
●
Connected to Power Line Wire (Black)
Connected to Power Ground Wire (Green)
GROUND TO
SWITCH BOX
LINE IN
230 VOLTS
plug
TO MOTOR
YELLOW
BLACK
WHITE
WHITE
RED
ORANGE
BLACK
BROWN
BLUE
GREEN
GREEN
Figure 3