Operation Manual

1. Connect the two loudspeakers using the supplied loudspeaker cable and the terminals
provided -1-/ -6-. Insert the core wires into the terminals while pressing the claw on the
speaker terminal.
2. Connect your signal source to the signal input socket -2-(RCA). In addition you are able to
connect an external subwoofer via the Subwoofer connection socket -3-(3.5 mm jack).
3. Connect the mains cable socket -4-with the mains cable supplied and plug it into your mains
socket.
Operation
1. Set the volume control to the minimum position Before you switch on the unit, turn the
volume control -12-to the minimum position (control to the left).
2. Switch on the power After all connections have been made, switch on the unit with the
On/Off switch -5-.
3. Volume control Adjust the volume with the volume control knob -12-.
4. Select signal input You have the choice between 2 possible signal input sources:
RCA -2
Bluetooth -7
-To connect a playback device via RCA, please connect the RCA cable of your external
player to the RCA sockets -2-of the DSM-3 BT Monitor 1 provided for this purpose.
NOTE Please make sure that the signal of your selected player is sufficient.
Someplayers, such as various turntables may require a pre-amplifier for
directconnection in order to obtain a sufficient signal.
-When using a Bluetooth player, first activate the Bluetooth function of the desired device and
then press the Bluetooth pairing button -7-on your DSM-3 BT monitor 1. When the DSM-3 BT
appears on your Bluetooth device, press connect. As long as you are in pairing mode, the
Bluetooth pairing LED -8-flashes. As soon as the connection is established, the Bluetooth pairing
LED -8-lights up continuously. To establish the connection to a new Bluetooth device, press the
Bluetooth pairing button -7-again to cancel the active Bluetooth connection and return to
pairing mode. Then repeat the procedure described above.
Sound Control