Operation Manual

-For reasons of safety and certification (CE) the unauthorised conversion and/or modification of
the device is prohibited. Please note that in the event of damage caused by the manual
modification to this device any warranty claims are excluded. -The inside of the device does not
contain any parts which require maintenance, with the exception of wear parts that can be
exchanged from the outside. Qualified staff must carry out maintenance, otherwise the
warranty does not apply! -The fuse must exclusively be exchanged against fuses of the same
class, with the same trigger features and nominal current rating. -Ensure that the power will
only be supplied after the device has been fully set up. -Only use cables that comply with
regulations. Observe that all jacks and bushes are tightened and correctly hooked up. Refer to
your dealer, if you have any questions. -Ensure that when setting up the product, the mains
cable is not squashed or damaged by sharp edges. -Prevent the mains cable from coming into
contact with other cables! Exercise great care when handling mains cables and connections.
Never touch these parts with wet hands! -Connect the power cable exclusively to appropriate
shock-proof outlets. The only supply point to be used is a supply outlet in accordance with
specifications of the public supply network. -Disconnect the device from the supply outlet when
not in use and before cleaning! Be sure to hold the mains plug by the body. Never pull the
mains cord! -Position the device on a horizontal and stable low-flame base. -Avoid any
concussions or violent impact when installing or operating the device. -When selecting the
location of installation, make sure that the device is not exposed to excessive heat, humidity
and dust. Be sure that no cables lie around openly. You will endanger your own safety and that
of others! -Do not rest any containers filled with liquid that could easily spill onto the device or
in its immediate vicinity. If, however, fluids should access the inside of the device, immediately
disconnect the mains plug. Have the device checked by a qualified service technician before
re-use. Damage caused by fluids inside the device is excluded from warranty. -Do not operate
the device under extremely hot (in excess of 35° C) or extremely cold (below 5° C) conditions.
Keep the device away from direct exposure to the sun and heat sources such as radiators,
ovens, etc. (even during transport in a closed vehicle). Always ensure sufficient ventilation. -The
device must not be operated after being taken from a cold environment into a warm
environment. The condensation caused hereby may destroy your device. Do not switch on or
operate the device until it has reached ambient temperature! -Controls and switches should
never be treated with spray-on cleaning agents and lubricants. This device should only be
cleaned with a damp cloth. Never use solvents or cleaning fluids with a petroleum base for
cleaning. -When relocating, the device should be transported in its original packaging.
-When starting operation, the volume controls of your Reloop DSM-3 BT monitors have to be
set to minimum and the device has to be switched off. Wait 8 to 10 seconds before turning up
the volume to avoid speaker damage.
-Devices supplied by voltage should not be left in the hands of children. Please exercise
particular care when in the presence of children. -At commercial facilities the regulations for the
prevention of accidents as stipulated by the organization of professional associations must be
observed. -At schools, training facilities, hobby and self-help workshops the operation of the
device must be monitored with responsibility by trained staff.