User's Manual

1-866-AMPLICOM (267-5426)
7
Getting Started — Included Equipment
t #BTF
t $PSEMFTT)BOETFU
t #BUUFSZ$PWFS
t #FMU$MJQ
t 1PXFS"EBQUFS
t 5FMFQIPOF$BCMF
t 3FDIBSHFBCMF"""7N"I
NiMH Battery Pack
Set up
1. Connect base
i. Plug the power adapter into the socket marked on the back of the
phone base and the other end into a wall socket.
ii. Plug the telephone cable into the socket on the back of the phone base.
Do not connect phone line to the phone wall socket yet.
Power
wall socket
Socket for Vibrate
Pad (PTV100)
available as
an accessory
GETTING STARTED
Important: Use only Power supply model S008CU1200067 supplied by Ten
Pao Industrial Co., Ltd. for Base unit.
Service Center
8
GETTING STARTED
2. Install battery pack
Insert the rechargeable battery pack into the handset and plug it in as shown.
Dispose of battery pack properly. Do not allow battery pack to come into
contact with re or water.
3. Charge handset
Place the handset on its base to charge for a minimum of 15 hours before use.
Important: Only use the rechargeable battery pack model GPHCH73N07, 750mAh
NiMH supplied by GPI INTERNATIONAL LIMITED.
4. Connect telephone cable
After initial charge, plug the telephone cable into the telephone wall socket.
5. Attach belt clip (optional)
Slide the belt clip into the two holes located on either side of the handset.
Your PowerTel 580 is now ready for use!
Caution: Risk of explosion
if battery is replaced by an
incorrect type. Dispose of
used batteries according
to the instructions.