User's Manual

1-866-AMPLICOM (267-5426)
39
Use on a private branch exchange
If the phone is on an exchange (e.g. dial 9 to get an outside line), calls can
be transfered or called back by using the R button. Check with the system
administrator for system set-up and instructions. Private exchanges are
normally used in a business-setting.
To set the recall time
1. Open the menu by pressing , then scroll using or until Base
settings is highlighted and press
.
2. Scroll using
or until Recall is highlighted and press .
3. The current recall timing setting (e.g. Short) will be displayed.
 $IPPTFUIFEFTJSFESFDBMMUJNJOHTFUUJOH4IPSUPS-POHVTJOH
or
and press .
Insert a dialing pause
Insert a pause before the dial tone if the system requires an outside line which
takes awhile to connect.
To insert a dialling pause, enter the number to reach the outside line and then
press
for two seconds. A P on the display will show dialing pause is active.
Note: A dialing pause can be used with a phone number in the phone book.
USE ON A PRIVATE BRANCH EXCHANGE
Service Center
40
USE ON A PRIVATE BRANCH EXCHANGE
Set the dial mode
There is a choice of two dialing modes: tone and pulse. The default setting is
TONE and this is the correct setting for use within the United States.
To change the dial mode
1. Open the menu by pressing , scroll using or until Base settings
is highlighted and press
.
2. Scroll using
or until Dial Mode is highlighted and press .
3. The current dial mode setting (e.g. Tone) is displayed.
 $IPPTFUIFEJBMNPEFTFUUJOHSFRVJSFE5POFPS1VMTFVTJOH
or and
press
.
Reset to default settings
Important: Reseting to default will NOT delete phone book entries.
To reset to default settings
1. Press for 10 seconds.
2. Conrm or cancel the reset to default settings by pressing
or .
USE ON A PRIVATE BRANCH EXCHANGE