User's Manual

1-866-AMPLICOM (267-5426)

GETTING STARTED

2. Install battery pack

Insert the rechargeable battery pack into the handset.

Dispose of battery pack properly. Do not allow battery pack to come into

contact with  re or water.

3. Charge handset

Place the handset on its base to charge for a minimum of 15 hours before use.

Important: Only use the rechargeable 750mAh NiMH battery pack supplied.

4. Connect telephone cable

After initial charge, plug the telephone cable into the telephone wall socket.

5. Attach belt clip (optional)

Slide the belt clip into the two holes located on either side of the handset.

Your PowerTel 500 is now ready for use!

Service Center

Previous menu

Con rm / OK

Phone book mode

More information to view left

More information to view right

Battery status

Ringer off

Keylock is on

Handsfree mode

Call in progress

Boost receiver volume is on

(Icon will  ash)

Mute handset microphone

New calls

When steady— handset is in

range

When  ashing — handset

is out of range

Internal call in progress (if

additional handsets are

installed)

Handset Display Icons

The following icons can appear in the handset display:

GETTING STARTEDGETTING STARTED

GETTING STARTED