User's Manual

1-866-AMPLICOM (267-5426)

USE ON A PRIVATE BRANCH EXCHANGE

Set the dial mode

There is a choice of two dialing modes: tone and pulse. The default setting is

TONE and this is the correct setting for use within the United States.

To change the dial mode

1. Open the menu by pressing , scroll using or until Base settings

is highlighted and press

2. Scroll using

or until Dial Mode is highlighted and press .

3. The current dial mode setting (e.g. Tone) is displayed.

4. Choose the dial mode setting required (Tone or Pulse) using

or and

press

Reset to default settings

Important: Reseting to default will NOT delete phone book entries.

To reset to default settings

1. Press for 10 seconds.

2. Con rm or cancel the reset to default settings by pressing

or .

Service Center

Help and support

Some issues may simply be resolved by disconnecting the power to the unit.

In such instances the power to the main base station should be switched off

and battery pack in the handset should also be removed for about 20 min-

utes. After 20 minutes, replace the battery pack and reconnect everything to

determine if this has resolved the issue.

Troubleshooting guide

I can’t make phone calls

1. Make sure the phone cable is connected properly. Make sure you are using

the phone cable that came with your phone.

2. Make sure the base is plugged in, switched on and working.

3. Make sure you are not located too far from the base (the phone should work

up to 325 yards outdoors and up to 52 yards indoors).

4. Test the phone line and socket by using another phone.

I keep losing my connection

1. Make sure you aren’t too far from the base (in ideal conditions, it should

work up to 325 yards outdoors and up to 53 yards indoors).

2. The base may not be in an ideal location – see Safety Information.

My handset keeps switching off

1. It may need recharging. So it can charge fully, place your handset on its charger

HELP AND SUPPORT

HELP AND SUPPORTHELP AND SUPPORT