Use and Care Manual

Operation Method
Cooling mode
 When the A/C enters cooling mode automatically or cooling mode is selected after
power ON, the cooling indicator lamp lights up.
 Press Up/Down key to adjust setting temperature (17°C~30°C).
 Press Speed key to choose High/Low speed.
Wind mode
 When pressing mode key or choosing wind mode by pressing the remote controller,
the wind indicator lamp lights up.
 Press Speed key to choose High/Low speed.
 Temperature can’t be set.
Dehumidification mode
 When pressing mode key or choosing dehumidification mode
by pressing the remote controller, the dehumidification
indicator lamp lights up.
 Remove the dehumidification water rubber stopper , insert
rubber hose , place the other end of the rubber hose into the
water container , as shown in the right figure.
 After entering the dehumidification mode, if room
tempearture≥15°C (59°F), the compressor is ON. Then
control as follows: when room temperature ≤13°C(55°F), the
compressor is OFF; when temperature increases to room
temperature≥15℃, the compre
ssor is started again (in order to protect the
compressor, it will be restarted 3min. later).
 In dehumidification mode, the fan is defaulted to run at low speed, and wind speed
can’t be adjusted.
 Temperature can’t be set.
（Tip: When dehumidification is adopted, exhaust duct assembly should be disassembled;
otherwise, dehumidification will be ineffectual and “FL” (full alarm) is displayed.）
Auto. mode (for cooling model only)
 When pressing mode key or choosing auto. mode by pressing the remote controller,
the auto. indicator lamp lights up.
 After choosing auto. mode, operation state is determined by environmental
temperature: when environmental temperature is higher than 25°C, the operation
state is the same as that of cooling mode; when environmental temperature is lower
than 25°C, the operation state is the same as that of wind mode.
Heating mode (for cooling and heating mode only)
 When pressing mode key or choosing heating mode by pressing the remote
contro
ller, the heating indicator lamp lights up.
 Press Up/Down key to adjust setting temperature (17°C~30°C).
 Press Speed key to choose High/Low speed.