Use and Care Manual

9
Button, press this button to select “Dry” or “dehumidifying” mode
Button, press this button to select “Sleep” function under cooling mode.
Before using your remote, install the AAA batteries into remote control.
1. Press and slide the battery cover on the back of the remote control, then you can remove the cover.
2. Insert two new alkaline AAA batteries into the battery compartment. Be sure to note the proper polarity.
3. Reattach the battery cover and make sure the locking tab clicks into place.
Notes:
 Use alkaline batteries only. Do not use rechargeable batteries.
 When replace batteries, always replace both batteries with new batteries, do not mix old and new batteries.
 If air conditioner will not be used for an extended period of time, remove the batteries from the remote
control.
CAUTION:
 If the liquid from the batteries gets onto your skin or clothes, wash it well with clean water, do not use the
remote control if the batteries have any leakage.
 If you eat the liquid from the batteries, brush your teeth and see doctor. The chemicals in batteries could
cause burns or other health hazards.
Multiple Protection Functions
1. Anti-freeze protection function:
Compressor, water spraying motor will turn off under cooling mode when compressor continuously running
over 10 minutes and tube temperature (Tp) is continuously ≦2℃ for 20 seconds under cooling mode, E4 will
show in LED display window, the unit initiates the anti-frost protection process and all buttons (except for
power button) are inactive.
Once the tube temperature ≧ 8℃, the protection is relieved to recover into original status, and compressor
apply to 3-minute delay protection.
2. Water-full safety alarm and shut –off protection function:
Warning sounds when the water volume reached its alarm level in water tank, and unit is automatically stop
Be sure to note proper
polarity of batteries