Installation Guide

Tools Needed
Power drill
Screwdriver
Installation
Do not connect the replace to the power supply ul properly xed to the wall and the
instrucons are carefully read.
Make sure the area to be drilled does not have any hidden electrical wires or water and gas
pipes.
The minimum distances must be observed as shown in the diagrams below.
During installon of the replace, avoid any possible damage to concealed cables.
Please be careful when drilling holes.
This replace is designed to be permanently xed to a wall. Choose a wall that is sturdy enough
to hold the weight of the replace such as a brick or cinder block wall. If posoning on drywall,
it must be xed to studs. If you are not sure if the wall is stable enough, then consult a hardware
expert. The wall bracket must be xed horizontally with the cable routed to the boom right of
the replace.
For omum viewing of the fuel bed, it is recommended that there be a distance of 2 feet from
the bom of the replace relve to the oor (see gure for recommended xed dimensions).
Step One
Keep the top of the replace at least 3 feet away from the ceiling or other objects for omum
heat veon.
For omum viewing, place four marks on the wall with respect to the recommended xed
dimensions for the top screws (see gure on next page).
Note: use a level when marking the posons of the holes to ensure that the bracket is mounted
horizontally.