Installation Guide

Use a 1/4 in. (6 mm) drill bit for drywall anchor

installation. Use a 1/8 in. (3mm) drill bit for direct

stud installation.

NOTE:

If installing into a material other than

drywall or into stud, consult a professional for

proper installation.

Measure and mark two bottom mounting

holes on the wall corresponding to the

pre-drilled hole locations in the bottom

mounting bar.

Draw horizontal line connecting the two bottom

marked location.the line should to be level.

adjust to level if necessary.

Attach the bottom mounting bar hanger to the wall with

two mountin screws from the hardware pack.

Step 1

Step 2