Instructions / Assembly

UNPACKING AND TESTING APPLIANCE
Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the
appliance operates properly by plugging the power supply cord into a conveniently located 110-120 Volt
grounded outlet.
【
Grounding
Grounding
Grounding
Grounding Appliance
Appliance
Appliance
Appliance
】
This appliance is for use on 120 Volts.
For connecting three-blade grounding type plugs to three -slot
receptacles. The green grounding lug extending from the
adapter must be connected to a permanent
ground such as
a properly grounded outlet box. The adapter should not be
used if a three-slot grounded
receptacle is available .
To disconnect appliance, turn controls to off, then remove
plug from outlet.
WARNING:
WARNING:
WARNING:
WARNING:
Keep the front of the appliance through which the heat is
radiated at least 1 meter away from furniture,
curtains and
other flammable objects at all time.
Never use an extension lead. The mains cable must
remain
at the back of the appliance and must not be in contact with
any hot elements.
【
【
【
【INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION】
】
】
】
WARNING:Find a safe location and build a suitable hole for fireplace.Minimum clearance from the ceiling and the mantel
must be at least 8 inches(200mm);
minimum clearance from the front must be at least 3 feet(900mm).Choose a location
near an outlet so an extension cord is not required.
Take model EF50 as an example.Prepare a wall with a framed opening of 46.5 inch(1180mm) wideX 21’’(533.4mm) high.
Make sure the width of the wood block on both sides which used to fix the fireplace is 3’’(76mm).Make sure that the
revealed wood block width on both sides is about 1 1/2’’(37.5mm) after finishing the plasterboard.Measure the depth
D from the plasterboard surface to the wood block and write it down.
MODEL EF36 EF42 EF50 EF60 EF72
A
32.5’’
(82 6mm) (978mm) (1180mm) (1435mm) (174 0mm)
21’’
38.5’’
46.5’’
56.5’’
68.5’’