Instructions / Assembly

User Instruction
17
TIPS: Before Beginning
● Read and understand the instructions thoroughly.
● Check and make sure that all parts are present.
● For future reference, save this instruction sheet.
1. Locate the burner control knob and make sure it is in the "OFF" position.
2. Connect propane (LP) cylinder. (See above pages).
3. Open LP tank valve slowly.
4. Push in igniter button to create sparks at the electrode and hold.
5. Push and turn burner control knob to the "LOW" position. Continue to push the control
knob for 15 seconds after ignition.
6. If ignition does not occur within few seconds, turn the burner control knob to "OFF", wait
5 minutes for gas to clear and repeat the lighting procedure. If burner still will not light, refer
to the Troubleshooting Section.
VISUAL CHECK
LEAK TEST
TO LIGHT
Prior to each use, check the hose and valve for excessive wear or abrasions.
1. Perform a leak test in a well ventilated area outside.
2. Make sure any open flames or cigarettes are extinguished.
3. Remove the battery.
4. Ensure the burner control knob is in the "OFF" position.
5. In a bowl, create a soap solution using 1 part water and 1 part liquid detergent.
6. Apply the soapy water solution to all connections.
7. Open LP tank valve.
8. A gas leak will be detected by expanding bubbles originating from the point of the leak.
9. If a leak is found at any connection point or if you smell gas, close the tank valve, disconnect
the tank and do not use the appliance until repairs can be made.