Instructions / Assembly

PUMP SAFETY & TROUBLESHOOTING

CARE AND MAINTANCE

1. Check regularly that the water reservoir has sufficient water to always cover the pump. It will

be necessary to check more frequently in warm or windy weather.

2. Do not allow the pump to freeze. During cold spells, remove the pump from the water feature

and place in a water-filled container in a frost-free position. DO NOT store the pump dry.

3. Periodically it will be necessary to change the water and clean the water feature and reservoir.

The frequency of this will depend on the weather and location of the water feature. The outside

of the water feature can be cleaned using a soft cloth and clean water and the reservoir with

a soft brush. A mild detergent can be used, but please note this will cause the water to foam

and should be avoided unless strictly necessary.

4. The pump rotor will require cleaning at approximately monthly intervals. A good indication

will be if the water flow rate drops. Unplug the water feature, remove the pump from the

water reservoir and disconnect the water pipe. Remove the filtering cover and pressure-casing

from the front of pump body. Clean the rotor and housing in clean water using cotton buds.

Reassemble the pump, reconnect the water pipe and reassemble the water feature.

Flow rate control

MIN

MAX

Min. water level

Filtering cover Housing

Rotor

Assembly Instruction