Instructions / Assembly

⚫ Do not expose the pump to direct sunlight or to low temperatures for any period of time.
⚫ Use only a UL-approved extension cord of the correct rating to avoid overheating.
⚫ Do not use attachments that are not provided by the manufacturer since they may cause an unsafe
condition.
⚫ Do not use the pump for anything other than its intended use.
ASSEMBLY INSTRUCTIONS
1. Put the top pot onto the fountain.
2. Connect the water hose preassembled on the top pot to the pump.
3. Connect the light cable preassembled inside of the fountain to the branch cable from the pump.
4. Connect the long cable from the pump to the transformer.
5. Gently pour water into the fountain, make sure the water completely submerges the pump.
6. Plug into your local power supply.
CAUTION: Make sure there is no water on the plug.
CARE AND MAINTENANCE
⚫ Check regularly that the water reservoir has sufficient water to cover the pump at all times. It will be
necessary to check more frequently in warm or windy weather.
⚫ Do not allow the pump to freeze. During cold spells, remove the pump from the water feature and
place in a water-filled container in a frost-free position. DO NOT store the pump dry.
⚫ Periodically it will be necessary to change the water and clean the water feature and reservoir. The
frequency of this will depend on the weather and location of the water feature. The outside of the
water feature can be cleaned using a soft cloth and clean water and the reservoir with a soft brush. A
mild detergent can be used, but please note this will cause the water to foam and should be avoided
unless strictly necessary.
⚫ The pump rotor will require cleaning at approximately monthly intervals. A good indication will be if
the water flow rate drops. Unplug the water feature, remove the pump from the water reservoir and
disconnect the water pipe. Remove the filtering cover and pressure-casing from the front of pump
body. Clean the rotor and housing in clean water using cotton buds. Reassemble the pump,
reconnect the water pipe and reassemble the water feature.
Page 2