Assembly Instruction 4 PIECE PATIO SOFA SET
PRE-ASSEMBLY PREPARATION WARNING! DO NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF FINGER ENTRAPMENT • Please read through this instruction before beginning assembly. • Two adults assembly is recommended. • Clear out the space for assembly and lay out all parts base on parts List, extra room will allow you to easily determine if all the pieces are present. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
PANEL AND FITTINGS IDENTIFICATION Left Arm Panel A Qty: 3 Right Arm Panel B Qty: 3 Front Leg E Qty: 6 Qty: 2 Rear Leg F Qty: 6 Table Top G Qty: 1 Back Panel C1 Single Seat Panel D1 Qty: 2 Back Panel C2 Qty: 1 Loveseat Panel D2 Qty: 1 Back Cushion O Qty: 4 Seat Cushion P Qty: 4 Table Leg H Qty: 4 HARDWARE LIST Bolt (I) M6 X 35mm Qty: 14 Bolt (J) M6 X 30mm Qty: 12 Bolt (K) Washer (L) Plastic Cap (M) M6 X 15mm Qty: 48 Qty: 74 Qty: 74 Wrench (N) Qty: 1 NOTE: From step 1 to st
Step 1 Attach Left Armrest Panel (A) and Right Armrest Panel (B) to Single Seat Panel D1 by using 4 long Bolts (I) and 4 Washers (L). Finally put Bolt Caps (M) until all parts have been connected and bolts are tightened. L I M B A D1 Step 2 Attach Back Panel (C1) to Armrest panels on both side by using 4 medium Bolts (J) and 4 Washers (L). Finally put Bolt Caps (M) until all parts have been connected and bolts are tightened.
Step 3 Attach Front Leg (E) and Rear Leg (F) to seat frame by using 12 short Bolts (K) and 12 Washers (L). Finally put Bolt Caps (M) until all parts have been connected and bolts are tightened. M K L F E Step 4 Put on Seat Cushion (P) and Back Cushion (O) to finish assembly of single sofa.
NOTE: From step 5 to step 8 is for loveseat sofa assembly. Please find panel A, B, C2, D2 and E, F firstly. Step 5 Attach Left Armrest Panel (A) and Right Armrest Panel (B) to Loveseat Panel D2 by using 4 long Bolts (I) and 4 Washers (L). L Finally put Bolt Caps (M) until all parts have been I connected and bolts are tightened.
Step 7 Attach Front Leg (E) and Rear Leg (F) to seat frame by using 12 short Bolts (K) and 12 Washers (L). Finally put Bolt Caps (M) until all parts have been connected and bolts are tightened. M K L F E Step 8 Put on Seat Cushion (P) and Back Cushion (O) to finish assembly of loveseat sofa.
NOTE: Step 9 is for table assembly. Please find panel H and G firstly. Step 9 Attach Legs (H) to Tabel Top (G) by using 12 short Bolts (K) and 12 Washers (L). Finally put Bolt Caps (M) until all parts have been connected and bolts are tightened. M H K G Step 11 7 Finished view for sofa set. Please make sure all bolts are properly tightened before use.
