Use and Care Manual

5
STEP 6
NO.
DESCRIPTION
SKETCH QTY
REQUIRED HARDWARE IN THIS STEP
1 PC
1
PC
WALL
6
7
WALL
5
NOT INCLUDED
NOT INCLUDED
NOT INCLUDED
WALL
4
1 PC
1
PC
PHILLIPS SCREW Ø 4*25mm
7
6
WALL ANCHOR Ø 8.5*30mm
5 ANTI-TIPPING STRIP
4 STEEL PLATE
REQUIRED HARDWARE IN THIS STEP
NO. DESCRIPTION SKETCH QTY
1PCALLEN WRENCH3
1PC4
1PC
STEEL PLATE
8 ALLEN BOLT M6*12mm
WALL
STEP 5
Attach steel plate (4) to the hole left open on the
outside of the top frame with allen bolt (8) using
allen wrench (3).
Place the shelves in the desired location. Mark the spot where the steel plate (4) meets the wall. Remove the shelves. Drill
a hole at the marked location and insert the wall anchor (6). Attach the remaining steel plate (4) to wall anchor (6) using
phillips screw (7). Return the shelves to the desired position and attach the steel plates (4) with anti-tipping strip (5).
Assembly is now complete.
5