Use and Care Manual

4
STEP 3
REQUIRED HARDWARE IN THIS STEP
NO. DESCRIPTION SKETCH QTY
2 ALLEN BOLT M6*30mm
1PCALLEN WRENCH3
REQUIRED HARDWARE IN THIS STEP
NO. DESCRIPTION SKETCH QTY
2 ALLEN BOLT M6*30mm
1PCALLEN WRENCH3
STEP 4
8PCS
16PCS
Attach top cross bar (H), middle short shelf cross bar (G), middle long shelf cross bar (F) and bottom cross bar
(E) with allen bolt (2) using allen wrench (3). DO NOT fully tighten bolts until all cross bars are attached.
Attach top panel (L), middle short shelf panel (K), middle long shelf panel (J) and bottom panel (I) to the
assembled frame as shown in the diagram with allen bolt (2) using allen wrench (3). Fully tighten all bolts.
E
F
G
H
E
F
G
H
2
2
2
2
2
2
2
2