User Manual

6. Use only the charger supplied with this scooter or a recommended replacement

specified by Glīon.

7. Charger supplied by Glīon is Model No. HP1202L3(90w), manufactured by High Power

Technology (KunShan) Inc. Operating temperature is 0℃ (32° F) ~ 40℃ (104° F).

WARNING: Failure to confirm compatibility, properly install,

operate and maintain any charger, component or accessory can result in

serious injury or death.

INSTRUCTIONS FOR CHARGING:

1. Turn the scooter off. The charge port (K) is located on the right side of the neck of the

scooter above the folding mechanism. Open the charge port rubber protective cover

and securely plug the charger into the charge port.

2. Plug the charger into the power outlet.

3. A solid red light on the charger indicates the battery is charging. A solid green light

indicates the battery is fully charged.

4. Remove the plug from the power outlet, then remove the charger from the scooter’s

charging socket. Secure the charge port rubber protective cover.

USAGE:

1. You will not damage the battery by riding the scooter until the battery is fully

discharged and the scooter motor shuts down. However, we do ask to promptly

recharge the battery after full discharge. Do not store your scooter with an empty

battery.

2. Avoid operating the scooter when the battery is hot.

BATTERY INDICATOR LIGHTS

1. The battery indicator screen is located on the right handle grip. When the scooter is turned on,

the battery indicator screen is lit.

2. F means the battery is fully charged. E indicates the battery is approaching empty.

3. The battery indicator screen is accurate when the motor is not engaged. When the scooter is

standing still, check the battery indicator for battery capacity status. Do not check the battery

indicator when operating the scooter.

4. Soft Riding Condition. When the battery is nearly depleted, a “soft” riding condition can occur.

A “soft” riding condition means the scooter can move forward under partial throttle but under

full throttle it shuts down. This occurs because under full throttle, a large instant current causes

the voltage to drop in the battery reaching the controller stop limit to protect the battery and

shut down the scooter. When this happens, turn the scooter back on and drive the scooter

under partial throttle until you can recharge the battery.

(K)