Quick Start Guide

DeletingParingInformation(Reset)
Resettheearbudswhentheearbudsdonotoperate
properlyoryouwanttodeleteparinginformationfrom
theearbuds.
①PressandholdbothMultifunctionbuttonson
therightandleftearbudsfor5secondswhile
theearbudsareplacedinthechargingcase.
TheLEDindicatorsontheearbudswillblink
whiteandredsixtimes.
②Deleteparinginformationonyourpaired
mobiledevice(ifitisalreadypaired).
Operationexample:
Settings>Bluetooth>SelectForgetThisDevice
orDisconnectforGLIDiCTW-6000.
③Redotheparingoperation.
→See"ParingtoConnectaDevice"
Siri/VoiceControlFunctions
UsetheMultifunctionbuttontooperatethisfunction
onmobiledevicesthatsupportSiriorothervoice
controlfunctions.
CheckingtheEarbudBatteryLevel
CheckwiththeLEDindicator
Ifthebatterylevelislow,theLEDindicatorswill
blinkredeveryminute.
PlayingMusicandVolumeControl
UsetheMultifunctionbuttontocontrol.
LMusic
R
Play/Stop
Skipforward
*1
Skipbackward
*2
Longpress(2sec)
*3
ー
ー
Pressonce
*1:Skipforwardjumpstothecueofthenexttrack.
*2:  Skipbackwardjumpstothecueoftheprevious(orinplayback)
track.TheoperationdependsonyourdeviceorOS.
*3:  Therightearbudswitchestopairingmodewhenlongpressing
morethan5seconds.
Doublepress
Doublepress
ー
Volumeup
Volumedown
LVoiceControl
R
Start/End
Presseitherthreetimes
ー
ー
L/R
red
Longpress(2sec)
*3
PhoneCall
UsetheMultifunctionbuttontocontrol.
LPhoneCall
R
Answeracall
End/declineacall
Answerthesecondcall*
Longpresseither
Presseitheronce
Endthefirstcall:Longpresseither
Holdthefirstcall:Presseitheronce
*:Itisavailableonlyifansweringsecondcallserviceisenabled.
Note)Microphoneisonlyavailablefortherightearbud.
Note)TurnSirioninSettingsonyouriPhone/iPadwhenSiri
doesnotstartup.
Thisdeviceisnotwaterproof.Donotuse
thisdeviceinrainorexposeittowater.
Stopusingthisdeviceimmediatelyifit
getswet.
Caution
©2020SBC&SCorp.Allrightsreserved.
V12009
PoweringOn/OfftheEarbuds
●Poweron
Removetheearbudsfromthechargingcase.
●Poweroff
Placetheearbudsinthechargingcase.
Note)Closethecaseaftercheckingtheearbudsareproperly
placed.
Chargingtheearbudsstarts.
L/R
・・・
white
L/R
red
Note)Microphoneisonlyavailablefortherightearbud.
65 7 8 9 10
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation.
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d' en compromettre le
fonctionnement.
FCC ID:2AO2PSB-WS61 IC:24766-SBWS61