User Manual
9
The batteries are 26350 3.7v. Only use the supplied charger and connect to an outlet via the
USB cable. Charge all batteries fully (Charge times vary, but are around 3hrs). Battery life varies
depending on how aggressively the gimbal is used ranging from 3-8hrs. The encoders increase
the battery life and don’t send power to the motors unless it’s needed. Store batteries 2/3rds
charged at room temperature. If batteries are not stored properly their life is greatly reduced.
#5 GLIDECAM CENTURION BATTERIES
Insert batteries in the battery compartment as shown
in Figure #8.
**NOTE**: The Glidecam CENTURION uses Lithium
Polymer batteries which can be extremely hazardous and
require special attention.
Figure 8
Figure 9
Figure 10










