User Manual
14
Once all three axis have been properly balanced,
double check all screws and knobs are securely
tightened. Your gimbal is ready to be powered on.
Locate the circular power switch located right above
the yaw motor and below the single battery grip.
Before pushing the power button in, make sure your
gimbal is completely still. The IMU sensor calibrates
at startup and the gimbal must be at rest for about 5
seconds after the Power Button is pushed.
**NOTE** Do not turn on the Glidecam CENTURION without
a camera attached. This can burn out the motors of the
Glidecam CENTURION.
#9 GLIDECAM CENTURION POWER ON
Push the power button.
You will hear the initiating beeps and the motors will
engage.
**NOTE** By default the Glidecam CENTURION calibrates
on startup and uses the last chosen prole. If movement
occurs during startup, the Glidecam CENTURION will skip
calibration and use the last used settings. This can be
changed in the software.
Figure 21
Figure 22