Installation Guide
Now your ready to install your second course of siding which you will repeat steps A, B & C
except your second course of siding you will install your siding hangers into the panel and
fasten them to the wall at 1’, 3’, 5’, 7’ etc. so that under the siding it will look like Figure
( D ) below
INSTALLATION INSTRUCTIONS
For example if you have a 12’ wall your first course of siding will be installed with 5 siding
hangers (2, 4, 6, 8, 10 spacing method) Your second course of siding will be installed with 6
siding hangers (1,3,5,7,9,11 spacing method) and the process will repeat itself through that wall.
If the spacing method falls out on a mount block, gable vent etc.. you will shift the hanger to the
left or right to remain within the 24”on center maximum spacing as close as possible. On
Horizontal applications with siding panels 16’8 or longer and more than one panel it is
recommended to place 1stay fastener in the center of the panel careful not to overdrive and
punch the center between the two factory nail slots to allow expansion and contraction. On
vertical siding application it is mandatory to place 1 stay fastener in the top of the nail slot
approximately 18” down from the top of the panel to prevent the siding panel from pushing
down on the bottom J channel
Page 2 of 2
1’ 3’ 5’ 7’ 9’ 11’
2’ 4’ 6’ 8’ 10’
2nd Siding Panel
1st Siding Panel
D