SDS

GP4-4110 UH 440 Satin Base- 1
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. Do not touch or walk through spilled material. Avoid breathing vapor or mist.
Provide adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Put on appropriate personal protective equipment (see Section 8).
Stop leak if without risk. Move containers from spill area. Approach release from
upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash
spillages into an effluent treatment plant or proceed as follows. Contain and collect
spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or
diatomaceous earth and place in container for disposal according to local regulations
(see section 13). Contaminated absorbent material may pose the same hazard as the
spilled product. Note: see section 1 for emergency contact information and section 13
for waste disposal.
Environmental precautions
6. Accidental release measures
:
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Personal precautions
:
Large spill
:
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up
if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and
place in an appropriate waste disposal container.
Small spill
:
Methods for cleaning up
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see section 10) and food and drink. Keep container tightly closed and sealed until ready
for use. Containers that have been opened must be carefully resealed and kept upright
to prevent leakage. Do not store in unlabeled containers. Use appropriate containment
to avoid environmental contamination. Keep from freezing.
Put on appropriate personal protective equipment (see Section 8). Eating, drinking and
smoking should be prohibited in areas where this material is handled, stored and
processed. Workers should wash hands and face before eating, drinking and smoking.
Remove contaminated clothing and protective equipment before entering eating areas.
Do not get in eyes or on skin or clothing. Do not ingest. Avoid breathing vapor or mist.
Use only with adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Keep in the original container or an approved alternative made from a
compatible material, kept tightly closed when not in use. Empty containers retain
product residue and can be hazardous. Do not reuse container. Keep out of the reach
of children.
7. Handling and storage
Handling
Storage
:
:
titanium dioxide
OSHA PEL (United States, 6/2010).
TWA: 15 mg/m³ 8 hour(s). Form: Total dust
OSHA PEL 1989 (United States, 3/1989).
TWA: 10 mg/m³ 8 hour(s). Form: Total dust
ACGIH TLV (United States, 1/2011). Notes: Substance identified by
other sources as a suspected or confirmed human carcinogen.
1996 Adoption Substances for which the TLV is higher than the
OSHA Permissible Exposure Limit (PEL) and/or the NIOSH
Recommended Exposure Limit (REL). See CFR 58(124) :36338-
33351, June 30, 1993, for revised OSHA PEL. Refers to Appendix A
-- Carcinogens.
TWA: 10 mg/m³ 8 hour(s).
Kaolin
ACGIH TLV (United States, 1/2011). Notes: 1996 Adoption Refers to
Appendix A -- Carcinogens. Respirable fraction; see Appendix C,
paragraph C.
TWA: 2 mg/m³ 8 hour(s). Form: Respirable fraction
8. Exposure controls/personal protection
Ingredient
Exposure limits
3/7
2014-04-09.