SDS

GLN6413N GLIDDEN PREMIUM INTERIOR SEMI-GLOSS PAINT+PRIMER - BASE 3
Product name
5.01
Product code
Date of issue
Version
00380468
20 April 2017
Section 6. Accidental release measures
Stop leak if without risk. Move containers from spill area. Prevent entry into sewers,
water courses, basements or confined areas. Wash spillages into an effluent treatment
plant or proceed as follows. Contain and collect spillage with non-combustible,
absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in
container for disposal according to local regulations (see Section 13). Dispose of via a
licensed waste disposal contractor. Note: see Section 1 for emergency contact
information and Section 13 for waste disposal.
Large spill
:
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up
if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and
place in an appropriate waste disposal container. Dispose of via a licensed waste
disposal contractor.
Small spill
:
Methods and materials for containment and cleaning up
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Do not store below the following temperature: 5°C (41°F). Store in accordance with
local regulations. Store in original container protected from direct sunlight in a dry, cool
and well-ventilated area, away from incompatible materials (see Section 10) and food
and drink. Keep container tightly closed and sealed until ready for use. Containers that
have been opened must be carefully resealed and kept upright to prevent leakage. Do
not store in unlabeled containers. Use appropriate containment to avoid environmental
contamination.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8).
:
Precautions for safe handling
Special precautions
:
If this material is part of a multiple component system, read the Safety Data Sheet(s) for
the other component or components before blending as the resulting mixture may have
the hazards of all of its parts.
Kaolin
ACGIH TLV (United States, 3/2016).
TWA: 2 mg/m³ 8 hours. Form: Respirable
fraction
OSHA PEL (United States, 6/2016).
TWA: 5 mg/m³ 8 hours. Form: Respirable
fraction
TWA: 15 mg/m³ 8 hours. Form: Total dust
Section 8. Exposure controls/personal protection
Ingredient name
Exposure limits
Control parameters
Occupational exposure limits
Key to abbreviations
United States
Page: 4/11