SDS

GMF2017 GLIDDEN MAX-FLEX EXTERIOR FABRIC PAINT AND PRIMER SATIN
ELEMENTAL
Product name
1
Product code
Date of issue
Version
00447061
8 December 2021
Section 6. Accidental release measures
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Approach release from upwind. Prevent entry into sewers,
water courses, basements or confined areas. Wash spillages into an effluent treatment
plant or proceed as follows. Contain and collect spillage with non-combustible,
absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in
container for disposal according to local regulations (see Section 13). Dispose of via a
licensed waste disposal contractor. Contaminated absorbent material may pose the
same hazard as the spilled product. Note: see Section 1 for emergency contact
information and Section 13 for waste disposal.
Large spill
:
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Dilute with water and mop up if water-soluble. Alternatively,
or if water-insoluble, absorb with an inert dry material and place in an appropriate waste
disposal container. Dispose of via a licensed waste disposal contractor.
Small spill
:
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Do not store above the following temperature: 50°C (122°F). Store in accordance with
local regulations. Store away from direct sunlight in a dry, cool and well-ventilated area,
away from incompatible materials (see Section 10) and food and drink. Protect from
sunlight. Store locked up. Eliminate all ignition sources. Use appropriate containment
to avoid environmental contamination.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Persons with a
history of skin sensitization problems should not be employed in any process in which
this product is used. Pressurized container: protect from sunlight and do not expose to
temperatures exceeding 50°C. Do not pierce or burn, even after use. Avoid exposure -
obtain special instructions before use. Avoid exposure during pregnancy. Do not
handle until all safety precautions have been read and understood. Do not get in eyes
or on skin or clothing. Do not breathe vapor or mist. Do not ingest. Avoid breathing
gas. Use only with adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Store and use away from heat, sparks, open flame or any other ignition
source. Use explosion-proof electrical (ventilating, lighting and material handling)
equipment. Use only non-sparking tools. Empty containers retain product residue and
can be hazardous.
:
Precautions for safe handling
Special precautions
:
Vapors may accumulate in low or confined areas or travel a considerable distance to a
source of ignition and flash back. Vapors are heavier than air and may spread along
floors. May form explosive peroxides. Keep away from combustible materials. Avoid
shock and friction. Avoid all possible sources of ignition (spark or flame). If this
material is part of a multiple component system, read the Safety Data Sheet(s) for the
other component or components before blending as the resulting mixture may have the
hazards of all of its parts.
United States
Page: 6/19