SDS

GMF1025 GLIDDEN MAX-FLEX ALL SURFACE INTERIOR/EXTERIOR PAINT AND
PRIMER SATIN SHINING ARMOR
Product name
2
Product code
Date of issue
Version
00447078
18 November 2021
Section 15. Regulatory information
SARA 313
SARA 313 notifications must not be detached from the SDS and any copying and redistribution of the SDS shall include
copying and redistribution of the notice attached to copies of the SDS subsequently redistributed.
Additional environmental information is contained on the Environmental Data Sheet for this product, which
can be obtained from your PPG representative.
California Prop. 65
Supplier notification
Chemical name
:
toluene
108-88-3
10 - 30
Aluminium powder (stabilized)
7429-90-5
1 - 5
2-(propyloxy)ethanol
2807-30-9
0.5 - 1.5
CAS number
Concentration
(Narcotic effects) - Category 3
HNOC - Defatting irritant
2-methoxy-1-methylethyl acetate
≥1.0 - ≤5.0
FLAMMABLE LIQUIDS - Category 3
SPECIFIC TARGET ORGAN TOXICITY (SINGLE EXPOSURE)
(Narcotic effects) - Category 3
2-(propyloxy)ethanol
≥1.0 - ≤5.0
FLAMMABLE LIQUIDS - Category 3
ACUTE TOXICITY (dermal) - Category 4
EYE IRRITATION - Category 2A
HNOC - Defatting irritant
WARNING
: Reproductive Harm - www.P65Warnings.ca.gov.
Section 16. Other information
Key to abbreviations
:
ATE = Acute Toxicity Estimate
BCF = Bioconcentration Factor
GHS = Globally Harmonized System of Classification and Labelling of Chemicals
IATA = International Air Transport Association
IBC = Intermediate Bulk Container
IMDG = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL = International Convention for the Prevention of Pollution From Ships, 1973
as modified by the Protocol of 1978. ("Marpol" = marine pollution)
Hazardous Material Information System (U.S.A.)
4
0
4
National Fire Protection Association (U.S.A.)
Health
Instability
Flammability
Health
Flammability
Physical hazards
Date of previous issue
11/16/2021
:
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or
risks. Although HMIS® ratings and the associated label are not required on MSDSs or products leaving a facility under 29 CFR 1910.1200, the
preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS® program. HMIS® is a registered trademark
and service mark of the American Coatings Association, Inc.
The customer is responsible for determining the PPE code for this material. For more information on HMIS®
Personal Protective Equipment (PPE) codes, consult the HMIS® Implementation Manual.
Organization that prepared
the SDS
:
EHS
:
:
:
:
:
:
3
*
3
0
( * ) - Chronic effects
United States
Page: 17/18